You will need to purchase corresponding dies to install these snaps with your KAM table press.
Each set includes 1 cap, 1 post, 1 socket, and 1 stud. Cap diameter is approx 19/32" (15mm). Prong length is 3/16" (5mm). Note: the center hole in the socket/female is smaller than the center hole in the stud/male, so caps and posts are not interchangeable. In other words, caps must be paired with sockets/females, and posts must be paired with studs/males.
Images below indicate only the colors. Actual style is shown above.
Disclosure: Different production batches may have very slight variances in appearance. This will be noticeable only on close inspection and should not affect functionality if applied properly.
Snaps are packaged by weight so count is approximate.